Installing the Side Clip GBIC
➀
3. Hold the GBIC
➂
the 1G-2GBIC
wide part of the 20-pin connector oriented upward as shown
4. Insert the GBIC (20-pin connector side) into the port slot
to the door hinge of the slot.
CAUTION: If the GBIC does not insert easily in this step, do not force it (check the
orientation against
port engages with the connector in the port slot
The door folds up and the GBIC slides into the port slot, engaging the sides of the GBIC and
port slot. The locking tab
Figure 3-4 Installing a Side Clip GBIC
Æ
Á
➀
GBIC with side clip
➁
Network connection end
➂
1G-2GBIC (Ethernet expansion module)
➃
20-pin connector (insertion end)
3-8
Hardware Installation
with the network port
. The 20-pin connector
Figure
3-4). Try again to push the GBIC into the slot until the 20-pin
➆
engages when the GBIC connector seats properly in the port.
Å
Æ
➁
on the insertion end (not shown) facing away from
➃
should be facing towards the empty slot, with the
➄
.
Â
Ä
Ã
À
➄
Port slot (door hinged side)
➅
Top of GBIC
➆
Locking tab
Figure
3-4.
with the top of the GBIC
➅
adjacent