CAUTION: To ensure proper ventilation and prevent overheating, leave a minimum
clearance space of 5.1 cm (2.0 in) at the left, right, and rear of the device.
WARNING: Before installing the chassis into a rack, ensure that the rack can support
the device(s) without compromising the stability of the rack. Otherwise, personal injury
and/or equipment damage may result.
ADVERTENCIA: Antes de instalar el chassis en un rack, asegurarse que el rack puede
soportar el(los) dispositivo(s) sin comprometer la estabilidad del mismo. De otra forma
puede suceder algun tipo de daño personal o del equipo.
WARNHINWEIS: Schützen Sie sich vor Verletzungen und Geräteschaden, überzeugen
Sie sich vor der Installation des Chassis in das Rack, von dessen Stabilität.
3.7.1.2
Installation
Rack mounting the device involves the following:
•
Attaching the strain-relief bracket
•
Rack mounting the device (attaching the mounting brackets and fastening the device to the rack)
3.7.2
Attaching the Strain-Relief Bracket
To attach the strain-relief bracket to the device, refer to
1. Locate the strain-relief bracket
device.
CAUTION: Do not attempt to attach the strain-relief bracket with screws other than the
M4 x 6 mm screws included with the device. Use of longer screws may damage the unit.
2. Place the device upside down (as shown in
strain-relief bracket
➀
and four M4 x 6 mm pan-head screws
➀
to the bottom of the device using the four M4 x 6 mm pan-head screws
Figure 3-9
Figure
3-9) on a clean flat surface. Then attach the
and proceed as follows:
➁
shipped with the
Hardware Installation
Installation
➁
.
3-17