Using The Reset Switch - Enterasys Matrix E1 1G587-09 Installation Manual

Using the Reset switch

4.3 USING THE RESET SWITCH
The Reset switch shown in
parameters to reset to the factory default settings.
CAUTION: Pressing the Reset switch resets the device, and all current switching being
performed by the device is halted. A network downtime of up to two minutes could result
from this action for any devices connected to the device.
Figure 4-2 Reset Switch
➀
Reset switch
To reset the device processor, press and release the Reset switch
process for approximately 30 seconds. Additional downtime may result as the device reenters the
network.
NOTE: Pressing the Reset switch while the device is already in reset mode is not
recommended. If the Reset switch is pressed while the device is in reset mode, the
device will enter an extended diagnostic procedure, which is unnecessary for normal
operation. This extended diagnostic procedure takes longer than two minutes to
complete.
4-6 Troubleshooting
Figure 4-1 resets and re-initializes the device, causing all user-entered
À
➀
. The device goes through a reset