This guide provides an overview, installation and troubleshooting instructions, and specifications
for the 1G582-09, 1G587-09, and optional expansion modules and Gigabit Interface Card
For information about the Command Line Interface (CLI) set of commands used to configure and
and manage the device, refer to the Enterasys Networks™ Matrix E1 Series (1G58x-09 and
1H582-xx) Configuration Guide.
NOTE: In this guide, the term 1G58x-09 is used when the information applies to both
the 1G582-09
devices, it is referred to by its model number.
Ethernet expansion module (or simply expansion module) refers to an optional
expansion card that plugs directly into an expansion port slot of the 1G58x-09
Gigabit Interface Card (GBIC) refers to an optional interface card that plugs into an
Ethernet expansion module that supports GBICs. The Enterasys Networks GBIC
models are GPIM-01, GPIM-08, and GPIM-09.
Depending on the firmware version used in the 1G58x-09, some features described in this
document may not be supported. Refer to the Release Notes shipped with the device to determine
which features are supported.
WHO SHOULD USE THIS GUIDE
This guide is intended for a network administrator responsible for installing and setting up the
1G58x-09 device.
and the
.
1G587-09
When the information applies to only one of the
Important Notice
About This Guide
About This Guide
GBIC
.
(
)
.
xvii