Installing the Locking Bar GBIC
3.5.2.1
Installing the Locking Bar GBIC
Prepare and install the GBIC into the 1G-2GBIC, as follows:
Preparation
Before installing the GBIC, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the GBIC from the antistatic packaging.
2. Remove the GBIC from the packaging.
3. If there is a protective dust cover on the port, remove it from the GBIC.
Installation
To install the GBIC, refer to
➀
1. Hold the GBIC
2. Lift the metal locking bar
the GBIC clips.
➀
3. Hold the GBIC
➅
connector
should be facing towards the empty port slot
adjacent to the door hinge of the port slot door.
4. Align the GBIC alignment slots
into the slot.
CAUTION: If, in the following step, the GBIC does not insert easily and stops about one
quarter of the way into the slot, do not try to push it in any further. Remove and check
the orientation against
20-pin port engages with the connector in the port slot.
➀
5. Push the GBIC
➇
slot
.
3-10
Hardware Installation
Figure 3-5
(Views A and B) and proceed as follows:
with the top of the body
➂
upwards as far as it will go. See
with the network port
➆
with the card guides inside the port slot
Figure
3-5. Try again to push the GBIC into the slot until the
back until the 20-pin connector port
➁
facing up, as shown in View A.
➃
facing away from the 1G-2GBIC
➇
➅
engages with the connector in port
Figure
3-5, View A. This unlocks
➄
. The 20-pin
. The top of the GBIC
➇
. The door folds up
➁
must be