Mgbic-02 Specifications (1000Base-T; Mgbic-Lc03 Specifications (1000Base-Sx; Mgbic-Lc04 Specifications (100Base-Fx; Mgbic-02 Specifications - Enterasys D2G124-12 Hardware Installation Manual

MGBIC-02 Specifications (1000BASE-T)

Table A-8 MGBIC-02 Specifications
Item
Supported Cable
Type:
Maximum Length
Connector
Data Rate
TX Output impedance
RX Input impedance

MGBIC-LC03 Specifications (1000BASE-SX)

Table A-9 MGBIC-LC03 Optical Specifications
Item
Transmit Power (minimum)
Transmit Power (maximum)
Receive Sensitivity
Link Power Budget
(Multimode Only)
1. The maximum drive distance (up to 2 km) depends on the quality of the installed multimode fiber-optic cable
segment. Use the Link Power Budget to calculate the maximum cable length of the attached segment. The
Link Power Budget must not exceed those specified in this table. The MGBIC-LC03 input power must not
exceed -3 dBm. Otherwise, saturation could occur.
Table A-10 MGBIC-LC03 Operating Range
Item
62.5 µm MMF
50 µm MMF

MGBIC-LC04 Specifications (100BASE-FX)

Table A-11 MGBIC-LC04 Optical Specifications
Item
Transmit Power (minimum)
Receive Sensitivity
Link Power Budget
1. The maximum drive distance (up to 2 km) depends on the quality of the installed multimode fiber-optic cable
segment. Use the Link Power Budget to calculate the maximum cable length of the attached segment. The
Link Power Budget must not exceed those specified in this table.
Specification
Copper, Category 5 UTP
Up to 100 meters
RJ45
1 Gbps, IEEE 802.3:2000 compatible
1000BASE-T operation only
Automatic crossover detection
100 ohms, typical at all frequencies between 1 MHz and 125 MHz
100 ohms, typical at all frequencies between 1 MHz and 125 Hz
62.5/125 µm MMF
-9.5 dBm
-3 dBm
-20 dBm
1
10.5 dB
Modal Bandwidth @ 1310 nm
160 MHz/km
400 MHz/km
62.5 µm MMF
-20 dBm
-31 dBm
1
(Multimode Only) 11 dBm
1-Gigabit Ethernet and 100Base-FX Transceiver (SFP) Specifications
Enterasys D-Series Hardware Installation Guide A-5
50/125 µm MMF
-9.5 dBm
-3 dBm
-20 dBm
10.5 dB
Range
2,000 Meters
2,000 Meters
50 µm MMF
-23.5 dBm
-31 dBm
7.5 dBm