Mounting The Switch; Installing The Switch Into A Rack - Enterasys D2G124-12 Hardware Installation Manual

Mounting the Switch

Mounting the Switch
The following mounting options are available for the D2 switch. Each requires that you purchase a
separate mounting kit. Proceed to mount the switch in your desired location using one of the
procedures described in this section:
• Install the switch in the rack mount kit and mount the switch to a 48.26‐centimeter (19‐inch)
rack or other secure location, as described in Installing the Switch into a Rack.
• Install the switch in a table mount kit and mount the switch under a table, as described in
"Installing the Switch Under a Table" on page 2‐10.
• Install the switch in a wall mount kit and mount the switch on a wall, as described in
"Installing the Switch on a Wall" on page 2‐12.
• Install the switch in a lockbox kit and mount the switch on a wall, as described in "Installing
the Switch in the Lockbox and Mounting on a Wall" on page 2‐15.

Installing the Switch into a Rack

The D2 switch can be single or dual‐mounted in a standard EIA‐310‐D compliant 48.26‐centimeter
(19‐inch) equipment rack. To mount one or two switches into a rack, you must first install each
switch into a rack mount kit as described in the following procedure. You must provide the
mounting hardware to attach the assembled kit to the rack rails.
Complete the following steps to install one or two switches in the rack mount kit:
1. "Positioning and Securing One or Two Switches" (page 2‐5)
2. "Installing One or More Power Supplies" (page 2‐6)
3. "Mounting the Assembled Kit Into a Rack" (page 2‐9)
4. "Connecting Power, Console, and Network Cables" (page 2‐9)
2-4 Installation
Caution: Before installing the screws as described in this installation procedure, refer to
Values" on page A-3.
Precaución: Antes de retirar los tornillos, tal como se describe en las instrucciones de instalación,
consulte "Torque Values" on page A-3.
Note: The D2-PWR-POE is taller than one rack unit high. If you have installed one or more
D2-PWR-POE power supplies in the rack mount kit, ensure that your rack installation location
leaves at least one rack unit of free space above the mounted assembly kit.
"Torque