Enterasys D2G124-12 Hardware Installation Manual page 27

This chapter provides the instructions to install the D2G124‐12 and D2G124‐12P. Unless otherwise
noted, the instructions apply to both switches.
Equipment needed:
• Anti‐static wrist strap
• Phillips screwdriver
Electrical Hazard: Only qualified personnel should install or service this unit.
Riesgo Eléctrico: Nada mas personal capacitado debe de instalar o darle servicio a esta unida.
Elektrischer Gefahrenhinweis: Installationen oder Servicearbeiten sollten nur durch
ausgebildetes und qualifiziertes Personal vorgenommen werden.
Depending on the mounting option you choose, and whether you decide to use the switch as a
freestanding device, the order in which you complete the D2 installation may vary. Use the
following table as a guideline:
For information about...
Unpacking the D2 Switch
Order of Installation Steps
Mounting the Switch
Connecting Power to the Switch
Connecting to the Console Port
Connecting to the Network
Installing the Optional Plastic Cover
Completing the Installation
Installation
Refer to page...
Enterasys D-Series Hardware Installation Guide 2-1
2
2-2
2-3
2-4
2-26
2-27
2-28
2-28
2-35