Mounting The Lockbox On The Wall; Attaching The Wire Relief Bracket - Enterasys D2G124-12 Hardware Installation Manual

Mounting the Switch
Figure 2-20
1 Screws (provided)
3. Insert the two screws provided and fasten securely.

Mounting the Lockbox on the Wall

The following procedure describes how to hang a fully configured D2 lockbox on the wall. You
may hang the lockbox over a data/power outlet or in a spot where power and data are provided
externally.
To mount the D2 lockbox on the wall:
1. Install the appropriate mounting screws to your desired wall location, as demonstrated by
Figure 2‐21 on page
2-22 Installation

Attaching the Wire Relief Bracket

Note: The D2 lockbox kit can only be mounted in a secure wall location. The kit is not designed for
table mounting or for use with a freestanding switch.
Caution: The wall location and wall mounting screws/anchoring method that the installer selects for
mounting the D2 lockbox and switch assembly must be capable of supporting 68 lbs (30.84kg).
Advertencia: La ubicación de la pared y el método de anclaje o los tornillos de montaje de la pared
que el instalador seleccione para montar la caja de seguridad y el conjunto del interruptor D2
deberán ser capaces de soportar un peso de 68 lbs (30.84 kg).
2‐23.
2 Wire relief bracket