Mounting The D2-Hipwr-Poe To The Wall Mounting Tray - Enterasys D2G124-12 Hardware Installation Manual

Mounting the Switch
5. Using the hook & loop strap provided, thread the strap through the mounting tray and over
the power supply in the following order:
a.
b. Through the opening in the mounting tray flange
6. Fasten the ends of the hook & loop strap securely around the power supply. Repeat Step
Step
7. (Optional) If mounting a D2‐HIPWR‐POE to the wall mounting tray, refer to Figure
proceed as follows:
Figure 2-12
''
1 Hook & loop fasteners with adhesive
a.
b. Once the hook & loop fasteners are adhered to the bottom of the D2‐HIPWR‐POE, remove
c.
2-14 Installation
Up through the mounting tray bracket at the side of the power supply
6 to secure a second power supply.

Mounting the D2-HIPWR-POE to the Wall Mounting Tray

With the hook and loop sides attached together, peel back the adhesive covering on one
side of each hook & loop fastener and apply to opposite corners on the bottom of the
D2‐HIPWR‐POE.
the adhesive covering on the other side of both hook & loop fasteners and adhere to the
table mounting tray.
Firmly press the D2‐HIPWR‐POE against the table mounting tray and hold together for a
few seconds.
5 and
2‐12 and