Installing The Switch In The Lockbox And Mounting On A Wall; Installing The Switch In The Lockbox - Enterasys D2G124-12 Hardware Installation Manual

8. Plug the DC power cord from the power supply into the switch DC power receptacle that is
appropriate for your type of power supply.
• For the D2‐PWR supply, plug into the PWR1‐A or PWR2‐A receptacle.
• For the D2‐PWR‐POE supply, plug into the PWR1‐B or PWR2‐B receptacle.
• For the D2‐HIPWR‐POE power combiner, see "Connecting a D2‐HIPWR‐POE Power
Combiner" on page 2‐25.
9. Plug the AC cord into the power supply's AC receptacle.
10. (Optional) Use the wire ties provided to secure the power cords inside the wall mounting tray.
11. Using appropriate screws and the screw holes in each corner edge of the wall mounting tray,
attach the assembled kit to your desired wall location. Secure the assembled unit in place by
positioning the screw holes over the installed wall screws and pulling slightly downward on
the unit.
12. Attach network cables. Refer to "Connecting to the Network" on page 2‐28 for more
information.
13. Plug each AC power cord into a dedicated, grounded AC outlet. See "Connecting Power to
the Switch" on page 2‐26 for information on redundancy and the initialization process.
14. (Optional) If you have purchased an optional plastic cover, attach it to the mounted D2 switch
as described in "Installing the Optional Plastic Cover" (page 2‐33).
Note: Once assembled, the serial number on the bottom of your D2 switch will be accessible
through the window on the bottom of the wall mounting tray. In the event you need to view it, you will
need to detach the wall mounting tray from the wall and (if installed) remove the power supply from
underneath the serial number window.

Installing the Switch in the Lockbox and Mounting on a Wall

To assemble the switch and other components in the D2 lockbox, proceed as described in the
following sections:
• Installing the Switch in the Lockbox
• Install your power supplies, following the steps in either "Installing Power Supplies"
(page 2‐16) or "Installing the D2‐HIPWR‐POE in the Lockbox" (page 2‐18)
• "Connecting Network Cabling and Attaching the Wire Relief Bracket" (page 2‐21)
• "Mounting the Lockbox on the Wall" (page 2‐22)
• "Attaching and Locking the Cover" (page 2‐23)
• "Removing the Lockbox Cover" (page 2‐25)

Installing the Switch in the Lockbox

To install the switch in the lockbox tray, proceed as follows:
1. Detach the lockbox key and place it in a secure location for later use.
Enterasys D-Series Hardware Installation Guide 2-15
Mounting the Switch