Installing The Optional Plastic Cover (Freestanding Switch Shown) - Enterasys D2G124-12 Hardware Installation Manual

Installing the Optional Plastic Cover
Figure 2-27
1 Cover mounting screws (four)
2 Cover mounting screw holes (four)
To install the plastic cover:
1. Align the fan and LED openings on the front panel of the plastic cover over the front panel of
the switch.
•
•
2. Secure the cover in place. When positioned securely, mounting tabs inside the edge of the
cover will snap into place into corresponding notches on the switch.
2-34 Installation

Installing the Optional Plastic Cover (freestanding switch shown)

If the switch is freestanding, front panel LEDs will align as shown in Figure
open end of the cover will align with the rear panel of the switch, allowing access to the
ports and network, power and console cables.
If the switch is mounted on the wall as shown in Figure
LEDs will face up (towards the ceiling), and the open end of the cover will face down
(away from the ceiling), allowing access to the ports and network, power and console
cables.
3 Cover mounting tabs
4 Switch mounting holes (four)
2‐11 on page 2‐13, front panel
2‐27, and the