Data Mapping; User Data Map; Default Data Map; Monitoring (Inputs From M10X) - ABB LVS Digital Manual

With m10x motor controller

Hide thumbs Also See for LVS Digital:

Table of Contents

DATA MAPP IN G

—

9. Data Mapping

Two possibilities exist for data mapping, the default data map as described below and a user

defined data map which can be created by the MNavigate Mapping Tool for project specific

tailoring of the communication data.

The default data map is a selection of data based on typical requirements. If this selection is

not accepted in the project, a user data map must be created.

All available data in a M10x can be assigned to the corresponding register addresses by using

the MNavigate Mapping Tool. This is a proprietary tool for ABB to program the MODBUS reg-

isters according to customer requirements.

Monitoring of the M10x data handled by the Digital Gateway is possible utilizing the following

function codes and address ranges.

FC 02

FC 03

FC 04

For LVS Digital Upgrade projects only:

For INSUM 1 Upgrade projects with Modbus RTU interface, a default Modbus mapping

is available for the interface between Digital Gateway and DCS. This mapping follows

the INSUM PK default mapping.

In addition to INSUM 1 PK mapping, INSUM 2 mapping for Digital Gateway is also avail-

able for INSUM 2 Upgrade solution with Modbus RTU interface.

1 TG C90 80 04

10001 .... 19999 Bit registers

40001 .... 49999

30001 .... 39999

Word registers

U S ER DATA MA P

Table of Contents