Data Mapping; User Data Map; Default Data Map; Monitoring (Inputs From M10X-M) - ABB M101 Manual

US ER DATA M AP
—

9.Data Mapping

Two possibilities exist for data mapping, the default data map as described below and a user
defined data map which can be created by the MNavigate Mapping Tool for project specific
tailoring of the communication data.
The default data map is a selection of data based on typical requirements. If this selection is
not accepted in the project, a user data map has to be created.

9.1. User Data Map

All available data in a M10x-M can be assigned to the corresponding register addresses by using
the MNavigate Mapping Tool. This is a proprietary tool for ABB to program the MODBUS reg-
isters according to customer requirements.

9.2. Default Data Map

9.2.1. Monitoring (Inputs from M10x-M)

Monitoring of the M10x-M data handled by the MNS Digital Gateway is possible utilizing the
following function codes and address ranges.
FC 02
FC 03
FC 04
For MNS Digital Upgrade projects only:
For INSUM 1 Upgrade projects with Modbus RTU interface, a default Modbus mapping
is available for the interface between MNS Digital Gateway and DCS. This mapping fol-
lows the INSUM PK default mapping.
In addition to INSUM 1 PK mapping, INSUM 2 mapping for MNS Digital Gateway is also
available for INSUM 2 Upgrade solution with Modbus RTU interface.
4 4
10001 .... 19999 Bit registers
40001 .... 49999
30001 .... 39999
Word registers
Word registers
DATA M A P PI NG
1TG C 9 0 8 0 0 4 M 0 2 0 1