Configurations; Initial Values - Ip Configuration - ABB LVS Digital Manual

CO NF IG UR AT IO NS
—

7. Configurations

7.1. Initial Values – IP Configuration
Digital Gateway requires parameter settings as initial values for network operation. The pa-
rameters are required depending on Digital Gateway configuration. Additionally, parameter
for Web Server, OPC Server and Fieldbus are also required.
The parameters must be loaded onto the Compact Flash (CF) card using MNavigate tool be-
fore powering up. After successful communication between MNavigate and Digital Gateway
(either direct or via network) the parameters can then be changed from MNavigate through
the network.
Any change of communication related parameter for Ethernet network (e.g. IP
address) requires a restart of Digital Gateway. Fieldbus communication related pa-
rameter (e.g. comm. speed, or slave address) can be change during runtime of Digital
Gateway.
Parameter
IP Address LAN 2 (LAN2)
Subnet Mask LAN2
Broadcast Address LAN2 192.168.200.255
Default Gateway LAN2
IP Address LAN 1 (LAN1)
Subnet Mask LAN1
Broadcast Address LAN1
Default Gateway LAN1
IP Address LAN 3 (LAN3)
Subnet Mask LAN3
1 TG C90 80 04
Default Value Range
192.168.200.100
255.255.255.0
0.0.0.0
192.168.100.100
255.255.255.0
192.168.200.255
0.0.0.0
192.168.171.100
255.255.255.0
I NITIA L VALU ES – IP CO NF IG UR AT IO N
Remarks
Settings according to network
administrator
Settings according to network
administrator
Calculated automatically
Settings according to network
administrator
DCS / SCADA communication inter-
face:
Settings according to network
administrator
Settings according to network
administrator
Calculated automatically
Settings according to network
administrator
LAN 3 for field device connectivity
via Modbus TCP
LAN 3 is not used
3 5