Table 5 Front View Connectors, Led And Push Buttons - ABB LVS Digital Manual

F RO NT VI EW
POWER SUPPLY
Button Reset
24V
GND
CF CARD
CF Card
PORTS
LAN 1
LAN 1 – LED left, green
LAN 1 – LED right, yellow
LAN 2
LAN 2 – LED left, green
LAN 2 – LED right, yellow
LAN 3
LAN 3 – LED left, green
LAN 3 – LED right, yellow
USB 1, 2
Serial 1
Serial 2
LED INDICATIONS
LED 1
LED 2
LED 3
LED 4
LED 5
LED 6
LED 7
LED 8

Table 5 Front View Connectors, LED and Push Buttons

1 4
Reset button (Restart of Digital Gateway)
Power Supply +24VDC
Power Supply 0V
CF card is protected against unintentional removal after clos-
ing the flap and connecting the power supply
LAN 1 Interface DCS / SCADA (Modbus TCP)
Link LAN 1 active
Communication Ethernet LAN 1
LAN 2 Interface (Switchgear Control Network)
Link LAN 2 active
Communication Ethernet LAN 2
LAN 3 Interface (field device connectivity via Modbus TCP)
Link LAN 3 active
Communication Ethernet LAN 3
Not used
Redundancy Interface (male plug)
Modbus RTU Interface (female plug)
Digital Gateway Run indication (CF card application loaded and
running)
Digital Gateway Fault
Application dependent (see section LED indication, page 60)
Application dependent (see section LED indication, page 60)
Application dependent (see section LED indication, page 60)
DCS Communication active
Digital Gateway Power On Indication
Application dependent (see section LED indication, page 60) In
redundant configurations: Digital Gateway primary
I NT ER FACES
1 TG C90 80 04