Table of Contents
Advertisement
QUICK START GUIDE
Introduction
This manual is intended as a guide in assisting equipment understanding and installation. This configuration of
the Slimline Power system (SPS) has one SPS Rectifier module and two Converter modules delivering -42 to -57VDC
at 100VA power Per Channel. This shelf has a total of 16 Output DC Channel with each Converter module having 8
Output channel, each output channel can support 100VA with individual LED status. The SPS Power express (PE)
shelf takes an input AC voltage of 100-120VAC 15A or 200-240VAC 7.5A which is fed to a single SPS rectifier unit.
The Slimline power system are available in four different configurations with battery/without battery for IEC - C19
or terminal block AC input connector type described in table 1 below. It supports a shelf Alarm card for shelf
status and fault indications with a controller. The AC input and DC output connections are available at the rear side
of the panel.
The Slimline power system shelf with IEC– C19 AC input measures (44mm (1.73") x 440.7mm (17.35") x 300.22mm
(11.82") (H x W x D). The Slimline power system shelf with Terminal block AC input measures (44mm (1.73") x
440.7mm (17.35") x 335.02mm (13.19") (H x W x D).
Controller
Phoenix terminal block
Phoenix terminal block
(AC Input)
IEC - C19
(AC Input)
SPS Shelf variants with Part number
Page 4
© 2021 ABB. All rights reserved.
Converter 1
Alarm card
SPS Shelf - front view
Battery Connection
SPS Shelf with terminal block connector - rear view
Battery Connection
SPS Shelf with IEC– C19 connector - rear view
Figure 1: SPS Shelf front and rear view
J2007003L301CB
J2007003L301C
J2007003L301AB
J2007003L301A
Table 1: SPS Shelf Variants
Converter 2
16 Channel DC Outputs
16 Channel DC Outputs
Description
SPS POWER EXPRESS SHELF WITH BATT
SPS POWER EXPRESS SHELF NO BATT
SPS POWER EXPRESS IEC-C19 SHELF WITH BATT
SPS POWER EXPRESS IEC-C19 SHELF NO BATT
Rectifier
Alarm Connections
Alarm Connections
Version 1.0
Advertisement
Table of Contents
