Figure 22. Removing the intrusion switch module
Next steps
Replace the intrusion
switch.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1. Align and insert the intrusion switch module until it is firmly seated in the slot on the system.
2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the system board.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
38
Installing and removing system components
Safety instructions
Before working inside your system
on page 25.
on page 26.