Power Interposer Board; Removing The Power Interposer Board; Installing The Power Interposer Board - Dell EMC PowerEdge R650xs Installation And Service Manual

Power interposer board

This is a service technician replaceable part only.

Removing the power interposer board

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the PSU or PSU
5. Disconnect the cables that are connected to power interposer board (PIB).
Steps
1. Using a Phillips #2 screwdriver, remove the screws securing the power interposer board to the system.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Lift the PIB away from the system.
Figure 123. Removing the power interposer board
Next steps
Replace the power interposer

Installing the power interposer board

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Safety instructions
Before working inside your system
blank.
board.
Safety instructions
Before working inside your system
on page 25.
on page 26.
on page 25.
on page 26.
Installing and removing system components 119