Removing The Right Control Panel - Dell EMC PowerEdge R650xs Installation And Service Manual

Figure 129. Installing the left control panel
Next steps
1. Install the air shroud.
2. Install the backplane cover.
3. Install the front bezel.
4. Follow the procedure listed in

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the front bezel.
4. Remove the backplane
5. Remove the air shroud.
Steps
1. Disconnect the control panel cable and the VGA cable from the system board connector and remove the cable from cable
clip.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
3. Hold the right control panel assembly and remove the control panel along with the cable from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your system
Safety instructions
Before working inside your system
cover.
on page 26.
on page 25.
on page 26.
Installing and removing system components 127