Figure 107. Removing the IDSDM module
Next steps
Replace the IDSDM
module.
Installing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1. Locate the IDSDM connector on the system board.
To locate IDSDM, see the System board jumpers and connectors section.
2. Align IDSDM module with the connector on the system board.
3. Push IDSDM module until it is firmly seated in the connector on the system board.
Safety instructions
Before working inside your system
on page 25.
on page 26.
Installing and removing system components
105