Figure 63. Set the anti-tilt wires to the locked position and tightening the captive nuts
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Expansion cards and expansion card risers
NOTE:
A system event entry is logged in the iDRAC Lifecycle Controller if an expansion card riser is not supported or
missing. It does not prevent your system from turning on. However, if a F1/F2 pause occurs with an error message,
see Troubleshooting expansion cards section in the Dell EMC PowerEdge Servers Troubleshooting Guide at
poweredgemanuals.
70
Installing and removing system components
After working inside your system
on page 26.
www.dell.com/