Figure 108. Installing the IDSDM module
Next steps
1.
Install the MicroSD
cards.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2.
Install the air
shroud.
3. Follow the procedure listed in the
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the expansion card
Steps
1. Open the blue latch to unlock the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
106
Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 26.
on page 25.
on page 26.