Figure 21. Installing a cooling fan
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Intrusion switch module
This is a service technician replaceable part only.
Removing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
3. Lift the intrusion switch module out of the system.
After working inside your system
Safety instructions
Before working inside your system
on page 26.
on page 25.
on page 26.
Installing and removing system components
37