System Battery; Replacing The System Battery - Dell EMC PowerEdge R650xs Installation And Service Manual

Figure 112. Installing the front mounting front PERC module
Next steps
1. Reconnect all the required cables.
2. If removed, install the air
3. Install the drive backplane
4. Follow the procedure listed in

System battery

This is a service technician replaceable part only.

Replacing the system battery

Prerequisites
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the expansion card
4. If applicable, disconnect the power or data cables from the expansion card(s).
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
110 Installing and removing system components
shroud.
cover.
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 26.
on page 25.
on page 26.