Microsd Card; Removing The Microsd Card; Installing The Microsd Card - Dell EMC PowerEdge R650xs Installation And Service Manual

MicroSD card

Removing the MicroSD card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the IDSDM module.
Steps
1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more
information on the slot location, see System board jumpers and connectors section.
2. Hold the MicroSD card and remove it from the slot..
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Figure 99. Removing the MicroSD card
Next steps
Install the MicroSD cards.

Installing the MicroSD card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: Ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the cards
during removal.
98 Installing and removing system components
Safety instructions
Before working inside your system
Safety instructions
Before working inside your system
on page 25.
on page 26.
on page 25.
on page 26.