Installing The Right Control Panel - Dell EMC PowerEdge R650xs Installation And Service Manual

Figure 130. Removing the right control panel
Next steps
Replace the right control

Installing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the front bezel.
4. Remove the backplane
5. Remove the air shroud.
Steps
1. Route the control panel cable through the latch, side wall of the system, and then slide the cable into the clip.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the right control panel in the slot on the system.
3. Connect the right control panel cable to the connector on the system board.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
128 Installing and removing system components
panel.
Safety instructions
Before working inside your system
cover.
on page 25.
on page 26.