Front Mounting Front Perc Module; Removing The Front Mounting Front Perc Module - Dell EMC PowerEdge R650xs Installation And Service Manual

Figure 110. Installing the OCP card
Next steps
1. Install the expansion card
2. Follow the procedure listed in

Front mounting front PERC module

This is a service technician replaceable part only.

Removing the front mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air
5. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the thumbscrews on the front PERC module.
2. Pull the front PERC module to disengage from the connector on the drive backplane.
3. Tilt and lift the front PERC module out of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
108 Installing and removing system components
riser.
After working inside your system
Safety instructions
Before working inside your system
cover.
shroud.
on page 26.
on page 25.
on page 26.