Table 36. Configuration 6: R2c (continued)
Card type
SolarFlare (OCP: 25Gb)
Broadcom (OCP: 10Gb)
Marvell (OCP: 10Gb)
Intel (OCP: 10Gb)
Broadcom (OCP: 1Gb)
Intel (OCP: 1Gb)
Dell External PERC Adapter
Dell BOSS S1 Module
Intel (PCIe SSD AIC)
Samsung (PCIe SSD AIC)
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
Steps
1. For Riser 1, hold the blue touch points, and lift the expansion card riser from the riser connector on the system board.
Figure 69. Removing the Riser 1
2. For Riser 2a, release the blue latch and hold the blue touch points, and lift the expansion card riser from the riser connector
on the system board.
80
Installing and removing system components
Slot priority
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
3
Integrated slot
3
3
Safety instructions
Before working inside your system
Maximum number of cards
1
1
1
1
1
1
1
1
1
1
on page 25.
on page 26.