Setting Up Pvc Connections; How Log And Alarm Messages Are Accessed And Displayed - Cabletron Systems SmartCell 6A000 User Manual

Switch Administration
Log Trace
Buffer
Remote
Clients
One parameter of set LogTrace is Quiet Mode,
which controls whether any Log Messages
are printed, reguardless of filtering.
Figure 4-4 How log and alarm messages are accessed and displayed
4.5

SETTING UP PVC CONNECTIONS

The SmartCell 6A000 supports permanent virtual circuits (PVCs), both point-to-point and point-to-multipoint. Use
PVCs to connect devices that do not support SVCs to a switch's local client or through the switch to form a PVC link
with other devices.
The SmartCell 6A000 supports PVCs for IP over ATM only.
Note
Use point-to-point PVCs to connect one end node to another for two-way communication. Use point-to-multipoint
PVCs to connect a broadcast end node to a group of receiving end nodes; traffic is one-way.
Modules & Submodules (SW)
Log Buffer
(Sys Mem)
Filter on
Set Log Trace
Set Log Alarm Mask
On / Off
Displays Logs
if set LogPrint is On
Console
Setting Up PVC Connections
Filter on
Alarm Message
Buffer
(Flash Mem)
Displayed by
Show Alarm
command
SmartCell 6A000 User Guide 4-13