Cabletron Systems SmartCell 6A000 User Manual page 27

Switch Installation and Setup
(alias = ): Change the values that currently define a switch-attribute.
modify set
: Start a process on the switch; for example, start the LAN Emulation Configuration Server.
start
: Restart a process on the switch; for example, restart a client.
restart
: Remove assigned values; for example, flush a route table.
flush
Entering parameters at the command line is optional. If a command requires parameter values, it prompts you for them.
For instance, in the example below,
indicating that you want to show information about "client 1".
SmartCell ZX # show client 1
LANE Client 1
===============================================================
Client State : Operational
Client Address : 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:14:41:81:00
LAN Name : elan2
LECS Addr Source : ILMI
LECS Address : 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:14:41:80:01
LES Address : 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:14:41:82:02
LAN Type : 802.3
MTU : 1516
IP Address : 200.200.100.254
IP NetMask : 255.255.255.0
SmartCell ZX #
If you don't specify parameters with the command, the console prompts you for a choice and provides a default value
displayed in parentheses. For example, if you enter
following appears:
SmartCell ZX # show client
ClientNumber(ALL)
Here, the default of " " clients is presented. You can either accept the default by pressing Enter, or you can enter a
all
specific client number. Accepting the default displays the following:
SmartCell ZX # show client
ClientNumber(ALL)
Client Type IP Address
============================================================================
0 LANE 200.100.100.254 LECS
1 LANE 200.200.100.254 LECS
2 IP/ATM 200.50.50.254
3 IP/ATM 200.50.40.254
SmartCell ZX #

When you accept the (
condensed.
Adding and Modifying
The and operators often need parameters. You can enter these parameters on the command line before
add modify
entering the command. If you don't enter the parameters, the switch prompts you for values.
is the operator,
show client
show client
:
:<Enter>
Server Type Server Conn
Established
Established
Local Established
Local Established
) default for
all show
is the switch-attribute, and
without specifying a client (as a parameter), the
Status
Operational
Operational
Operational
Operational
, the information displayed is often
SmartCell 6A000 User Guide 2-9
Using the Console
is the parameter
1