Technical Specifications - Owon SDS1052 User Manual

8. Technical Specifications

Unless otherwise specified, the technical specifications applied are for the
oscilloscope only, and Probes attenuation set as 10X. Only if the oscilloscope fulfills
the following two conditions at first, these specification standards can be reached.
 This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
 If change of the operating temperature is up to or exceeds 5℃, do a
"Self-calibration" procedure (see "How to Implement Self-calibration" on P12).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Performance Characteristics
Bandwidth
Channel
Mode
Acquisition
Sample rate
(real time)
Input coupling
Input impedance
Input coupling
Max. input voltage
Channel –channel
Input
isolation
Time delay between
channel(typical)
Bandwidth limit
Sampling rate range
Interpolation
Max Record length
Horizontal
System
Scanning speed (S/div)
Sampling rate / relay
time accuracy
8.Technical Specifications
SDS1022
SDS1052
SDS1102
2 channels
Normal, Peak detect, Averaging
SDS1022
SDS1052
SDS1102
DC, AC , Ground
1 MΩ±2%, in parallel with 20 pF±5 pF
1X，10X，100X，1000X
400V (DC+AC, PK - PK)
50Hz: 100 : 1
10MHz: 40 : 1
150ps
SDS1022
SDS1052
SDS1102
SDS1022
SDS1052
SDS1102
(Sinx)/x
10K
SDS1022
SDS1052
SDS1102
±100 ppm
57
Instruction
20 MHz
50 MHz
100 MHz
100 MS/s
500 MS/s
1 GS/s
Not support
20 MHz, full bandwidth
0.5 S/s～100 MS/s
0.5 S/s～500 MS/s
0.5 S/s～1 GS/s
5 ns/div – 1000 s/div,
step by 1 – 2 - 5
2 ns/div – 1000 s/div,
step by 1 – 2 - 5