Sidestand - Yamaha EGO GEAR Owner's Manual

Instrument and control functions
To use the power outlet
1. Turn the vehicle power off.
2. Remove the power outlet cap.
3. Turn the accessory off.
4. Insert the accessory plug into the
power outlet.
5. Turn the vehicle power on and
start the engine.
6. Turn the accessory on.
5
TIP
When nished riding, turn off the ac-
cessory and disconnect it from the
power outlet, and then install the cap.
1. Power outlet cap
WARNING
To prevent electrical shock or short-
circuiting, install the cap when the
power outlet is not in use.
5-14
EWAN0050

Sidestand

The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
• The built-in sidestand switch is
part of the ignition circuit cut-off
system, which cuts the ignition in
certain situations. (See the follow-
ing section for an explanation of
the ignition circuit cut-off system.)
• When the sidestand is lowered,
the Stop and Start System is de-
activated.
WARNING
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in ful lling the respon-
EAU76780
EWA10242