Handlebar Switches - Yamaha EGO GEAR Owner's Manual

Handlebar switches

Left
1. Dimmer switch " / "
2. Turn signal switch " / "
3. Horn switch " "
Right
1. Stop and Start System switch "
2. Hazard Light switch " / OFF"
3. Start switch " "
Dimmer switch "
EAU1234H
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Start switch "
Push this switch while applying the
front or rear brake to crank the engine
with the starter. See page 7-2 for start-
ing instructions prior to starting the en-
gine.
"
A A
Instrument and control functions
EAU12401
/ "
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
EAU12501
"
EAUM1133
"
5-7
Hazard switch " "
With the key in the "ON" position, use
this switch to turn on the hazard lights
(simultaneous ashing of all turn signal
lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traf c hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Stop & Start System switch "
(forEGO GEAR)
To on the Stop & Start system push
to the position " ". To off the Stop
A
& Start system push to the position
" ".
A
EAU66010
5
ECA10062
"
A
A