Yamaha EGO GEAR Owner's Manual page 61

Periodic maintenance and adjustment
2. If dirt or water is visible, remove
the hose from the clamp, clean it,
and then install it.
TIP
If dirt or water was found in the check
hose, be sure to check the V-belt case
air lter element for excessive dirt or
damage and clean or replace it if nec-
essary.
Cleaning the V-belt case air lter el-
ement
1. Place the vehicle on the center-
stand.
2. Remove the screws, and then pull
8
the V-belt case air lter element
cover outward and away from the
V-belt case.
1. V-belt case air lter element cover
2. Bolt
3. Pull the V-belt case air lter ele-
ment out, and then clean it with
solvent. After cleaning, remove
the remaining solvent by squeez-
ing the element. WARNING! Use
only a dedicated parts cleanin
solvent. To avoid the risk of re
or explosion, do not use gaso-
line or solvents with a low ash
point. NOTICE: To avoi
[EWA10432]
damaging the air lter element,
handle it gently and carefully,
and do not twist it.
[ECA10522]
8-18
1. V-belt case air lter element
4. Apply oil of the recommended
type to the entire surface of the
sponge material,
squeeze the excess oil out.
TIP
The air lter element should be
wet but not dripping.
and then