Further Safe-Riding Points - Yamaha EGO GEAR Owner's Manual

Safety information
Point the front wheel straight
ahead on the trailer or in the truck
bed, and choke it in a rail to pre-
2
vent movement.
Secure the motorcycle with tie-
downs or suitable straps that are
attached to solid parts of the mo-
torcycle, such as the frame or up-
per front fork triple clamp (and not,
for example, to rubber-mounted
handlebars or turn signals, or
parts that could break). Choose
the location for the straps carefully
so the straps will not rub against
painted surfaces during transport.
The suspension should be com-
pressed somewhat by the tie-
downs, if possible, so that the mo-
torcycle will not bounce exces-
sively during transport.

Further safe-riding points

Be sure to signal clearly when
making turns.
Braking can be extremely dif cult
on a wet road. Avoid hard braking,
because the motorcycle could
slide. Apply the brakes slowly
when stopping on a wet surface.
Slow down as you approach a
corner or turn. Once you have
completed a turn, accelerate
slowly.
Be careful when passing parked
cars. A driver might not see you
and open a door in your path.
Railroad crossings, streetcar rails,
iron plates on road construction
sites, and manhole covers be-
come extremely slippery when
wet. Slow down and cross them
with caution. Keep the motorcycle
upright, otherwise it could slide
out from under you.
2-5
EAU57610
The brake pads or linings could
get wet when you wash the motor-
cycle. After washing the motorcy-
cle, check the brakes before
riding.
Always wear a helmet, gloves,
trousers (tapered around the cuff
and ankle so they do not ap), and
a brightly colored jacket.
Do not carry too much luggage on
the motorcycle. An overloaded
motorcycle is unstable. Use a
strong cord to secure any luggage
to the carrier (if equipped). A loose
load will affect the stability of the
motorcycle and could divert your
attention from the road. (See page
2-3.)