Sidestand - Yamaha Star XVS95B Owner's Manual

3
9
5 6 7 8
1 2 3 4
(a)
1. Special wrench
2. Extension bar
3. Position indicator
Spring preload setting:
Minimum (soft):
1
Standard:
4
Maximum (hard):
9
3. Install the panel.
WARNING
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.
INSTRUMENT AND CONTROL FUNCTIONS
G
Do not tamper with or attempt to
open the cylinder assembly.
G Do not subject the shock ab-
sorber assembly to an open
1
flame or other high heat source.
(b)
This may cause the unit to ex-
plode due to excessive gas
pressure.
2
G Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
damping performance.
G Do not dispose of a damaged or
worn-out shock absorber as-
sembly yourself. Take the shock
absorber assembly to a Yamaha
dealer for any service.
EWA10221

Sidestand

The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
(See the following section for an expla-
nation of the ignition circuit cut-off sys-
tem.)
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
4-14
WARNING
EAU15305
4
EWA10241