Sidestand; Starting Circuit Cut-Off System - Yamaha TT-R50EY 2008 Owner's Manual

1. Projection
2. Seat holder
2. Place the seat in the original posi-
tion, and then tighten the bolts.
TIP
Make sure that the seat is properly se-
cured before riding.
INSTRUMENT AND CONTROL FUNCTIONS

Sidestand

The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
WARNING
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
3-8
EAU37490

Starting circuit cut-off system

The starting circuit cut-off system pre-
vents starting when the transmission is
in gear.
Periodically check the operation of the
starting circuit cut-off system according
EWA14190
to the following procedure.
TIP
This check is most reliable if performed
with a warmed-up engine.
EAU41611
3