2. System Description
This section identifies the system components and describes the external interfaces of the system.
2.1.
System Components
The images below show the typical system components of the oMG 500.
Figure 1 - oMG 500
Figure 2 - Power Cable
Figure 3 - Multi-radio External Antenna
The base unit contains the CPU, hard drive, and communication interface cards. On the outside of the
unit are the LAN and WAN ports, a GPS port, the power connector, the power reset switch, and the
status LEDs.
The power cord typically connects to the electrical system of the vehicle.
oMG-ED-130507
Rev 1.2
October 2, 2015
10