Connecting A Dc Power Cable - Sierra Wireless AirLink GX450 Hardware User's Manual

AirLink GX450 Hardware User Guide
Ethernet LEDs
Connection speed
Figure 2-19: Ethernet LEDs
The Ethernet connector has two LEDs that indicate speed and activity. When looking into
the connector:
•
•
Power-up and Reboot
On power-up or reboot, the LEDs go through a booting sequence. When the boot is
complete, the Power and Network LEDs should be green, signifying that the power is on,
the GX450 gateway is connected to the wireless network, and there is a good signal. See
Table 2-3
To reboot the GX450 gateway, either:
•
•

Connecting a DC Power Cable

The GX450 gateway has a four-pin power connector that has:
•
•
Rev. 11 July 2019
Activity— The right LED is solid amber when a link is detected (the cable is plugged
in) and blinks when there is activity.
Connection Speed—The left LED is green to indicate a 100 Mbps connection and
orange to indicate a 10 Mbps connection. It is off when no cable is connected.
on page 30 for detailed LED operation.
In ACEmanager, click the Reboot button at the top right of the screen.
Or
Press and release the Reset button on the GX450 gateway (see
page 8).
Two pins connecting DC voltage to the gateway
Two pins providing additional monitoring and control functions
Activity
32
Front Panel on
4114008