Areca ARC-1880 Series User Manual page 170

APPENDIX
(3). SNMP Trap Notification Configurations
Please refer to
C-3-3 Using In-band PCI + SNMP extension agent Installa-
tion
By using the IP address assigned to the operating- RAID control-
ler using Areca SNMP extension agent through PCIe host bus
interface.
a). Set only "Community" field and select the "SNMP Port" option
on the firmware-embedded SNMP configuration function. There is
no function to set other fields on "SNMP System Configuration".
The SNMP community and SNMP port can setup by using browser-
based manager or CLI SNMP configuration. To launch the above
browser-based RAID controller SNMP function, click on the "Sys-
tem Controls" link. The "System Controls" menu will show avail-
able items. Select the "SNMP Configuration" item. The following
"SNMP System Configuration" screen is launched by browser-
based manager.
About community, Community name acts as a password to screen
accesses to the SNMP agent of a particular network device. Type
in the community names of the SNMP agent. Before access is
granted to a request station, this station must incorporate a valid
community name into its request; otherwise, the SNMP agent will
deny access to the system.
Most network devices use "public" as default of their community
names. This value is case-sensitive.
170
Chapter 2 of Event Notification Configurations.