Areca ARC-1880 Series User Manual page 111

ARCHTTP PROXY SERVER INSTALLATION
1. Login as root. Copy the ArcHttp file to a local directory.
(1). Insert the 6Gb/s SAS RAID controller CD in the CD-ROM drive.
(2). Copy <CD-ROM>\PACKAGES\Linux\http directory to local (Ex:/
usr/local/sbin). Or
(3). Download from the www.areca.com.tw or from the email
attachment.
2. You must have administrative level permissions to install 6Gb/s
SAS RAID controller ArcHttp proxy server software. This procedure
assumes that the 6Gb/s SAS RAID hardware and driver are
installed and operational in your system.
The following details are the installation procedure of the 6Gb/s
SAS RAID controller for Linux ArcHttp proxy server software.
(1).Run the Archttp proxy server by using the following command:
Usage: ./archttp32 (TCP_PORT) or ./archttp64 (TCP_PORT). It
depends on your OS version.
Parameters: TCP_PORT value= 1~65535 (If TCP_PORT assigned,
Archttp will start from this port. Otherwise, it will use the setting in
the archttpsrv.conf or default 81). This is the port address assigning
for the archttp configuration (Cfg Assistant).
Such as: archttp64 1553
(2). Archttp server console started, Controller card detected then
ArcHttp proxy server screen appears.
Copyright (c) 2004 Areca, Inc. All Rights Reserved.
Areca HTTP proxy server V2.00 for Areca RAID controllers.
Controller(s) list
--------------------------------------------
Cfg Assistant : Listen to port[1553].
Controller[1](PCI) : Listen to port[1554].
Binding IP:[0.0.0.0]
Note: IP[0.0.0.0] stands for any ip bound to this host.
--------------------------------------------
##############################
111