Areca ARC-1880 Series User Manual page 169

C-3-2 Using Onboard NIC Installation
By using the built-in LAN port on the RAID controller- RAID con-
troller using built-in LAN interface. You can use the browser-based
manager or CLI SNMP configuration to setup the firmware-based
SNMP configuration. The following screen is the firmware-embed-
ded SNMP configuration setup screen using browser-based man-
ager:
To launch the above browser-based RAID controller SNMP func-
tion, click on the "System Controls" link. The "System Controls"
menu will show available items. Select the "SNMP Configuration"
item.The firmware-embedded SNMP agent manager monitors all
system events and the SNMP function becomes functional with no
agent software required.
(1). SNMP Trap Configurations
Enter the SNMP Trap IP Address.
(2). SNMP System Configurations
Community name acts as a password to screen accesses to the
SNMP agent of a particular network device. Type in the com-
munity names of the SNMP agent. Before access is granted to a
request station, this station must incorporate a valid community
name into its request; otherwise, the SNMP agent will deny ac-
cess to the system. Most network devices use "public" as de-
fault of their community names. This value is case-sensitive. The
system Contact, Name and Location that will be shown in the
outgoing SNMP trap.
APPENDIX
169