B.6: Template 6: Single Hazard - 2 Zones Cross-Zoned With All Active - Honeywell Notifier RP-2001 Instruction Manual

Pre-action/deluge control panel
Table of Contents

Advertisement

Template 6: Single Hazard - 2 Zones Cross-Zoned With All Active
B.6 Template 6: Single Hazard - 2 Zones Cross-Zoned With
All Active
Template 6: SINGLE HAZARD - 2 ZONES CROSS-ZONES WITH ALL ACTIVE
OUTPUT CIRCUITS
#1 ALARM NAC
#2 WATERFLOW NAC
#3 SUPV. BELL NAC
#4 RELEASE SOLENOID 1
Table Legend:
X = direct correlation between Input Zone and Output Circuit (input zone activation will turn on
corresponding output circuit).
Cx = cross-zone where x is the number of the Release Solenoid. All inputs with the same Release
Solenoid number must be active at the same time to turn on the corresponding solenoid output
circuit
Input Zone Types:
Zone 1 = 2-wire smoke
Zone 2 = Fire
Zone 3 = Waterflow - activation delayed for 10 seconds (Waterflow Delay set to 10 secs.)
Zone 4 = Manual Release
Zone 5 = Pull Station
Zone 6 = Low Pressure
Output Circuit Types:
Output 1 = Alarm NAC, silenceable, coded for steady on
Output 2 = Waterflow NAC - activation delayed for 10 seconds (Waterflow Delay set to 10
secs.), silenceable, coded for steady on
Output 3 = Supervisory Bell NAC, silenceable, coded for steady on
Output 4 = Release Solenoid 1 (unsupervised for shorts)
Timers
Soak Timer 1 - set for 10 minutes
Soak Timer 2 - set for 10 minutes
Waterflow Delay Timer - set for 10 seconds
AC Loss Delay Timer - set for 2 hours
Operation
Activation of both Input Zone 1 (2-Wire Smoke) and Zone 2 (Fire) at the same time, or Zone
4 (Manual Release) or Zone 5 (Pull Station) will operate the Release Solenoid 1 Output #4.
Release Solenoid will turn off water release following time-out of the 10 minute Soak Timer 1.
Activation of any one of these zones will operate Alarm NAC Output #1
Activation of Input Zone 3 (Waterflow) will operate the Waterflow NAC Output #2. There is a
10 second FACP initiated delay in activation since Waterflow Delay Timer is set to 10 seconds
Activation of Input Zone 6 (Low Pressure) will operate the Supervisory Bell NAC Output #3
RP-2001 Series Manual — P/N 52985:D5 1/26/2017
1
2
2-WIRE SMOKE
FIRE
X
X
C1
C1
FACP Configuration Templates
INPUT ZONES
3
4
MANUAL
WATERFLOW
RELEASE
X
X
X
5
6
PULL
LOW
STATION
PRESS.
X
X
X
107

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Notifier rp-2001eNotifier rp-2001c

Table of Contents