Time-Date - Honeywell Notifier RP-2001 Instruction Manual

Programming
To enter alphanumeric characters from the keypad, repeatedly press the appropriate key until the
desired character is displayed in the first position. For example, to enter the letter B, press the 2
(ABC) key three times to toggle through the characters 1, A, and B. Press the right arrow key to
move the cursor one position to the right and repeat the process to enter the next character. To enter
a space, press the * (QZ) key four times to place a blank in the desired position. When all characters
have been entered, press the Enter key to store the information. The display will return to the Select
Banner Screen.

Time-Date

SYSTEM SETUP
1=TIME-DATE
2=TROUBLE REMIND The control panel time and date can be changed by pressing 1 while viewing the System Setup
3=CHARGR DISABLE
Screen #2. The following screen will be displayed:
System Setup Screen #2

To change the time, press 1 while viewing the Time-Date Screen. The following screen will be
displayed:
A flashing cursor is located toward the top left of the display. Below the cursor is the current time.
To change the time, enter the two-digit hours followed by the two-digit minutes. The cursor will
move one position to the right each time a digit is entered. After the last minutes digit is entered, the
cursor will again move one position to the right. At this point enter 1 for AM or 2 for PM. The
display will then return to the Time-Date Screen which will show the new time entry. If an error is
made while entering a digit, press the CLR key to delete the entire entry and beginning again.

To change the date, press 2 while viewing the Time-Date Screen. The following screen will be
displayed:
A flashing cursor is located toward the top left of the display. Below the cursor is the current date.
To change the date, enter the two-digit month followed by the two-digit day and then the two-digit
year (14 for 2014, 15 for 2015, etc.). The cursor will move one position to the right each time a
digit is entered. After the last year digit is entered, the display will return to the Time-Date Screen
which will show the new date entry. If an error is made while entering a digit, press the CLR key to
delete the entire entry and beginning again.
64
TIME AND DATE
1=TIME
2=DATE
3=CLOCK FORMAT
Time-Date Screen #1
Time
Date
TIME AND DATE
10:00A
1=DAYLIGHT SAVINGS
09182014
12HR
Time-Date Screen #2
ENTER TIME AS 12HRS
:
10:00
1=AM 2=PM
Time Screen
ENTER DATE
--
MONTH DAY YEAR
09-19-2014
Date Screen
RP-2001 Series Manual — P/N 52985:D5 1/26/2017
Master Programming Level