Table of Contents
Advertisement
Master Programming Level
While viewing any Zone Type screen, select the type of zone being programmed by pressing the
corresponding keyboard number key. The display will return to Edit Input Zone Screen #2 and indi-
cate the selection next to the Type option.
Output Circuit Map
INPUT ZONE #
1=OUTPUT CIRCUIT MAP
2=FREEZE SUPV.
Output Mapping (per input zone) allows the programmer/operator to assign the Output Circuits that
Edit Input Zone Screen #3
will be activated when a particular Input Zone or cross-zoned releasing group goes active. Pressing
1 for Output Circuit Map while viewing Edit Input Zone Screen #3 will display screens which show
the Output Circuits programmed to activate when the selected Input Zone (or cross-zoned releasing
group) is activated. Output Map Screen #1 displays the Output Type Codes and programming for
Output Circuits 1 through 3 and Output Map Screen #2 displays the Output Type Code and pro-
gramming for Output Circuit 4.
As an example, if Template 1 has been selected as the FACP Configuration [refer to"FACP
CONFIG (Application Templates)" on page 51], selecting the Output Circuit Map for Input Zone 1
will display the following screens:
The screens indicate that when Input Zone 1 is activated:
RP-2001 Series Manual — P/N 52985:D5 1/26/2017
N/A
N/A
Waterflow
Waterflow NS (nonsilenceable)
Combo
Combo w/AutoResettable Superv
2-Wire Smoke
2-Wire Heat
N/A
Linear Heat
N/A
N/A
Fire
Low Pressure
Low Pressure AutoResettable2
High Pressure
High Pressure AutoResettable2
3
Disable Release
Supervisory
Supervisory AutoResettable2
N/A
2nd-Shot Water Switch
1 Activation of a Manual Release Switch will override Predischarge Delay, resulting
in an immediate water release.
2 AutoResettable means that a device with this type code, when activated, will
automatically reset when the corresponding condition is cleared.
3 Disable Release allows the installer to disable the releasing solenoids during
system testing. Disable Release will only work when the system is not in alarm.
4 The 2nd-Shot Water Switch provides the option of performing another immediate
water release manually. Refer to "2nd-Shot Water Switch" on page 81.
OUTPUT MAP ZONE 1
1=ALARM
NAC
2=WATERFLOW NAC
3=RELEASE 1
Output Map Screen#1
Output Circuit #1 default programmed as Alarm NAC will activate (Yes)
2
Fire/Supervisory, nonlatching
Supervisory, nonlatching
Supervisory, nonlatching
Supervisory, nonlatching (disables Release Circuits)
Supervisory, nonlatching
4
Fire Alarm, nonlatching
Table 3.1 Zone Types
OUTPUT MAP ZONE 1
4=SUPV BELL NAC N/A
YES
NO
YES
Output Zone Screen#2
Fire
Fire, nonsilenceable
Fire/Supervisory
Fire Alarm
Fire Alarm
Fire Alarm
Fire Alarm
Supervisory, latching
Supervisory
Supervisory, latching
Programming
53
Hide quick links:
Advertisement
Table of Contents
