JUNKERS CL1 G-BUYU
HINGING THE RUDDER.
Glue the top two rudder hinges in place
using the same techniques used to hinge
the ailerons.
The lower hinge will be glued when the
fin/rudder assembly is attached to the fu-
selage.
INSTALL RUDDER CONTROL HORN.
Repeat steps to install the rudder control
horn as same as steps done for ailerons.
Fiberglass control horn
20
Instruction Manual.
Rudder fiberglass control horn.
INSTALLING VERTICAL STABILIZER
1) While holding the vertical stabilizer
firmly in place, use a pen and draw a
line on each side of the vertical stabilizer
where it meets the top of the fuselage.
2) Using a modeling knife, remove the
covering from over the precut hinge slot
cut into the lower rear portion of the fu-
selage.
Epoxy.
Pen