JUNKERS CL1 G-BUYU
Hold the stabilizer in place with T-pins
or masking tape and remove any excess
epoxy using a paper towel and rubbing
alcohol. Allow the epoxy to fully cure be-
fore proceeding.
Hinge.
ELEVATOR PUSHROD
INSTALLATION.
Elevator control horn.
1) Thread one clevis and M2 lock nut on
to the elevator control rod. Thread the
clevis on until it is flush with the end of
the control rod.
2) Elevator pushrod assembly as pictures
below.
M2 clevis.
Fuel tubing.
22
C/A glue.
.
Elevator pushrod.
Hex nut.
Instruction Manual.
Pen.
M2 lock nut.
8mm
8mm
Nylon Snap Keeper.
RUDDER PUSHROD INSTALLATION.
Repeat steps as same as steps done for
elevator.
.
M2 clevis.