Aileron Pushrod Installation; Installing The Fuselage Servos - Seagull Models JUNKERS CL1 G-BUYU Assembly Manual

AILERON PUSHROD INSTALLATION.

Please see below pictures.
Use a felt tip pen to mark the wire where
it crosses the hole. Use a pair of pliers to
put a shrp 90-degree bend in the wire at
the mark.
Bend at the mark
M2 lock nut.
8mm
Snap keeper.
Servo arm.
Snap keeper.
Mark.
.
.
Metal clevis.
Fuel tubing.

INSTALLING THE FUSELAGE SERVOS.

Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
1) Install the rubber grommets and brass
collets into all servos. Test fit the servos
into the fuselage servo mounts.
2) Secure the servos with the screws pro-
vided with your radio system.
Throttle servo.
THROTTLE SERVO ARM
INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
Nylon Snap keeper.
Hex Nut.
.
Rudder servo.
Elevator servo.
7