Westfalia OSD 6-91-067 Instruction Manual page 150

150
Fig. 255
Note:
Due to the design concept used, the spindle is at an inclined angle relative to
the opposite side of the motor when the drive belt has not been fitted or ten-
sioned (see Fig. 256, pos. 2)
The spindle is pulled into the centric axis when the belt is tensioned (see Fig.
256, pos 1)!
Fig. 256
Fig. 257
Westfalia Separator
Mineraloil Systems GmbH
• Fasten the motor with four hex head
screws 2 (M 12 x 30).
• Unscrew hex head screw 1 (with
hexagon nut and washer) from the
centrifugal clutch.
• Remove the hoist.
• Check
– that the spindle 1 can be turned
easily.
– whether the spindle has been
pulled into the centric axis by
tensioning the drive belt 3 (see
Fig. 162).
• Insert gasket 1 in the upper section
of frame.
• Fit operating-water feeding system 2
and
• bolt tight with four hex head screws
3 (M 8 x 12).
2058-9001-101 / 0506